Part Number
DEMIL
Shelf Life
UOM
NIIN
NSN
National Stock Number:
TXT
Description:
Thrust Ball Bearing
MRC:
The distance measured in a straight line from the bottom to the top of an item.ABKW
Overall Height:
Between 0.3540 inches and 0.3640 inches
MRC:
The overall length of a straight line which passes through the center of an item,and terminates at the outside circumference.ADGA
Overall Outside Diameter:
1.0470 inches
MRC:
The length of a straight line which passes through the center of the smallest diameter of a bore,and terminates at the circumference.AGWJ
Bore Smallest Diameter:
0.4000 inches
Largest Bore Diameter:
0.3750 inches
MRC:
An additional finishing process by which the surface of an item is altered in respect to polishing,grinding,and the like.AGYE
Surface Finish:
Unground
MRC:
The means used in manufacturing the retainer.AGYF
Retainer Fabrication Method:
Molded
MRC:
Indicates the type of alignment utilized whereby the item will adjust axially for misalignment.AGZA
Alignment Type:
Rigid
MRC:
A designation of the directional operating capability of the item.AGZQ
Thrust Directional Capability Designation:
Single
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Steel
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the item.STYL
Style Designator:
Grooved race surface, banded od
MRC:
The specification,standard,drawing,or similar instrument that specifies environmental and performance requirements or test conditions under which an item is tested and establishes acceptable limits within which the item must conform identified by an alphabetic and/or numeric reference number. includes the commercial and government entity (cage) code of the entity controlling the instrument.TEST
Test Data Document:
98230-0n067016 drawing (this is the basic governing drawing, such as a contractor drawing, original equipment manufacturer drawing, etc.; excludes any specification, standard or other document that may be referenced in a basic governing drawing)
