Part Number
DEMIL
Shelf Life
UOM
NIIN
Part Information
environmental temp 300 degrees f. After stress relief hardened to rockwell 45n 51.6-56. End item application 2350-01-087-1095 tank, armd battlem1a1
NSN
National Stock Number:
TXT
Description:
Compression Helical Spring
MRC:
The length of a straight line which passes through the center of a circular figure or body,and terminates at the inside circumference.AARX
Inside Diameter:
0.710 inches
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the end.ABQK
End Style:
E4 spring end, squared and ground both ends
MRC:
The length of a straight line which passes through the center of a circular bore,and terminates at the circumference.ABXV
Bore Diameter:
0.802 inches
Spring Free Length:
2.150 inches
MRC:
The length of a straight line which passes through the center of the accommodated rod,and terminates at the circumference.AHQJ
Accommodated Rod Diameter:
0.519 inches
MRC:
A numeric value that reflects the hardness of the material when used in conjunction with a hardness rating scale.ALME
Material Hardness Rating:
45.0 rockwell superficial 45-n
MRC:
The number of coils included on the item.APCN
Coil Quantity:
10
Spring Solid Length:
0.982 inches
Spring Solid Outside Diameter:
0.775 inches
MRC:
An indication of the coil helix direction.AXLH
Coil Helix Direction:
Right-hand
MRC:
The weight,per specific measurement scale,required to deflect the spring.AXLP
Spring Deflection Rate:
30.600 pounds per inch
Spring Free Outside Diameter:
0.750 inches
MRC:
The metallic,nonmetallic,and/or chemical properties with which the item is plated,dipped,and/or coated.the treatment is designed to protect the surface(s) and cannot be wiped off.SFTT
Surface Treatment:
Oil
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the item.STYL
Style Designator:
Cylindrical
MRC:
The specification,standard,drawing,or similar instrument that specifies environmental and performance requirements or test conditions under which an item is tested and establishes acceptable limits within which the item must conform identified by an alphabetic and/or numeric reference number. includes the commercial and government entity (cage) code of the entity controlling the instrument.TEST
Test Data Document:
19207-12267595 drawing (this is the basic governing drawing, such as a contractor drawing, original equipment manufacturer drawing, etc.; excludes any specification, standard or other document that may be referenced in a basic governing drawing)
