Part Number
DEMIL
Shelf Life
UOM
NIIN
NSN
National Stock Number:
TXT
Description:
Engine Accessory Generator
MRC:
A measurement of the extent of threads,including incomplete threads,along a line parallel to the longitudinal axis.AASA
Thread Length:
0.844 inches
MRC:
A measurement of the longest dimension of the tapered portion of an item,in distinction from width.ABND
Taper Length:
1.156 inches
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the mounting.ADER
Mounting Style:
Body mtd w/four threaded mtg holes
Pilot Height:
0.438 inches
MRC:
The environmental elements or conditions that an item is designed or protected to resist or withstand satisfactorily.ADZC
Environmental Protection:
Corrosion resistant and fungus resistant
MRC:
The length of a straight line which passes through the center of a circular figure or body,and terminates at the largest circumference.AGQA
Largest Diameter:
1.250 inches
MRC:
An indication of whether or not an item is capable of operation while submerged.AHZV
Submersibility:
Nonsubmersible
MRC:
The direction of rotation of a rotating shaft as viewed from the drive end.AKCT
Shaft Rotation Direction:
Clockwise
MRC:
The minimum speed the armature can revolve and maintain full current output,expressed in revolutions per minute.BCGD
Armature Minimum Speed In Rpm At Full Current Output:
1880
MRC:
The maximum amount of output current for which the item is rated,expressed in amperes.BCGF
Maximum Output Current Rating In Amps:
60.0
MRC:
The means by which the item is grounded.BCGN
Grounding Method:
Internal
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the shaft drive end.BCGS
Shaft Drive End Style:
Tapered shaft end, threaded w/keyway
Distance From Raised Face To First Mounting Hole Center:
5.156 inches
Angular Deviation Of First Hole From Top Center In Deg:
90.0
Angular Deviation Of Second Hole From First Hole In Deg:
90.0
Distance From Raised Face To Second Mounting Center:
9.719 inches
MRC:
A designation distinguishing one group of thread diameter-pitch combinations from another by the number of threads per measurement scale for the specific diameter of a threaded mounting hole.CMLK
Mounting Hole Thread Series Designator:
Unf
MRC:
The length of a straight line which passes through the center of a threaded mounting hole,and terminates at the circumference.CMLL
Mounting Hole Thread Diameter:
0.375 inches
MRC:
The number of mounting hole threads per linear inch measured on a line parallel to the thread axis.CMLM
Mounting Hole Thready Qty Per Inch (tpi):
24
MRC:
The total electrical voltage.ELEC
Voltage In Volts:
24.0
