Part Number
DEMIL
Shelf Life
UOM
NIIN
Part Information
0.280 in. Distance from edge of gasket to center of bolt holes
NSN
National Stock Number:
MRC:
The style designation indicating the configuration that most nearly corresponds to the cross-sectional shape of the item.AAGR
Cross Sectional Shape:
Solid single or composition
MRC:
The length of a straight line which passes through the center of a hole,and terminates at the circumference.AAUB
Hole Diameter:
0.400 inches
MRC:
The dimension measured along the longitudinal axis with terminated points at the extreme ends of the item.ABHP
Overall Length:
9.000 inches
MRC:
A value which expresses the degree of heat or cold as applied to the operation,or limitation of operation,of an item.ABJH
Tempurature Rating:
-20.0 degrees fahrenheit and 120.0 degrees fahrenheit
MRC:
An overall measurement taken at right angles to the length of an item,in distinction from thickness.ABMK
Overall Width:
2.250 inches
MRC:
A measurement of the line segment extending from the center of a circle or sphere to the curve of an inside corner.ADPQ
Inside Corner Radius:
0.250 inches
Outside Corner Radius:
0.250 inches
MRC:
A measurement taken at right angles to the length of an aperture,in distinction from thickness.ADUE
Aperture Width:
1.130 inches
MRC:
A measurement of the longest dimension of an aperture,in distinction from width.ADUF
Aperture Length:
8.620 inches
MRC:
A measurement of the center to center distance between the bolt holes along the length.ADUZ
Center To Center Distance Between Bolt Holes Along Length:
6.500 inches
Outside Edge To Bolt Hole Center Distance Along Length:
1.250 inches
MRC:
A measurement of the smallest dimension of a cross section,in distinction from length or width.ADVM
Cross-sectional Thickness:
0.125 inches
MRC:
The number of bolt holes provided on the item.AECS
Bolt Hole Quantity:
4
MRC:
A numeric value that reflects the hardness of an item when used in conjunction with a hardness rating scale.CQFM
Hardness Rating:
40.0 shore durometer a and 50.0 shore durometer a
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Rubber butadiene-styrene class sbr
MRC:
The specification,standard,or manufacturers reference,and the classification designation,such as class,condition,temper,and the like,that identifies the material.MDCL
Material Specification:
Mil-r-900 military specification single material response
MRC:
Test conditions and ratings,or environmental and performance requirements that are different,more critical,or more specific than those specified in a governing test data document.SPCL
Special Test Features:
Special quality control testing
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the item.STYL
Style Designator:
Non-circular
MRC:
Characteristics or qualities of an item,not covered in any other requirement,which are considered essential information for one or more functions excluding nsn assignment.SUPP
Supplementary Features:
As differentiated by material which must conform to ships parts control center special quality control provisions
MRC:
The specification,standard,drawing,or similar instrument that specifies environmental and performance requirements or test conditions under which an item is tested and establishes acceptable limits within which the item must conform identified by an alphabetic and/or numeric reference number. includes the commercial and government entity (cage) code of the entity controlling the instrument.TEST
Test Data Document:
81349-mil-p-23199 specification (includes engineering type bulletins, brochures, etc., that reflect specification type data in specification format; excludes commercial catalogs, industry directories, and similar trade publications, reflecting general type data on certain environmental and performance requirements and test conditions that are shown as "typical", "average", "", etc.).
