Part Number
DEMIL
Shelf Life
UOM
NIIN
NSN
National Stock Number:
TXT
Description:
Bushing Insulator
MRC:
The length of a straight line which passes through the center of a circular figure or body,and terminates at the inside circumference.AARX
Inside Diameter:
Between 0.120 inches and 0.230 inches
MRC:
The included angle of the countersink,expressed in degrees.AATA
Countersink Angle In Deg:
82.0
MRC:
The length of a straight line which passes through the center of a circular figure or body,and terminates at the outside circumference.ABKV
Outside Diameter:
0.312 inches
MRC:
The distance measured in a straight line from the bottom to the top of an item.ABKW
Overall Height:
0.220 inches
MRC:
The maximum potential gradient that the insulating material can withstand per mil /0.001 inch/ thickness without rupture.ACGY
Dielectric Material Voltage Rating Per Mil Thickness In Volts:
Not rated
MRC:
The length of a straight line which passes through the center of the shank,and terminates at the outside circumference.AGGZ
Shank Outside Diameter:
0.160 inches
MRC:
A measurement from the bottom to the top of the shank,in distinction from depth.AQZQ
Shank Height:
0.115 inches
MRC:
The geometric configuration of the end/s/ when viewed in cross section.BSPB
End Configuration:
Both ends squared
MRC:
The element,compound,or mixture of which the item is fabricated,excluding any surface treatment,and its location.MTLC
Material And Location:
plastic, l-p-509, type 4, grade g-10 err-100 err-100
MRC:
The element,compound,or mixture of which the item is fabricated,excluding any surface treatment,and its location.MTLC
Material And Location:
plastic, l-p-509, type 4, grade g-10
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the item.STYL
Style Designator:
Shoulder
MRC:
The specification,standard,drawing,or similar instrument that specifies environmental and performance requirements or test conditions under which an item is tested and establishes acceptable limits within which the item must conform identified by an alphabetic and/or numeric reference number. includes the commercial and government entity (cage) code of the entity controlling the instrument.TEST
Test Data Document:
81348-fed-l-p-509**zzzsgc293172-2-06845*zzzkjn06845-c293172-2 specification (includes engineering type bulletins, brochures, etc., that reflect specification type data in specification format; excludes commercial catalogs, industry directories, and similar trade publications, reflecting general type data on certain environmental and performance requirements and test conditions that are shown as "typical", "average", "", etc.).
