Part Number
DEMIL
Shelf Life
UOM
NIIN
Part Information
Coaxial cable assemblies, radio frequency
NSN
National Stock Number:
TXT
Description:
Radio Frequency Cable Assembly
MRC:
The style designation indicating the configuration that most nearly corresponds to the cross-sectional shape of the item.AAGR
Cross Sectional Shape:
Round
MRC:
A measure of the opposition to the flow of electrical current.AAPP
Electrical Resistance:
50.00 ohms impedance
MRC:
The length of a straight line which passes through the center of a cross section,and terminates at the outside circumference.ADVL
Cross Section Outside Diameter:
0.400 inches
MRC:
The national stock number or the identification information of the end equipment for which the item is a part.AGAV
End Application:
C-130 amp
MRC:
The number of electrical conductors included on the item.AMQN
Conductor Quantity:
1
MRC:
The master requirement codes of those requirements which are technically critical by reason of tolerance,fit,performance,or other characteristics which affect identification of the item.CRTL
Criticality Code Justification:
Agav
MRC:
Those unusual or unique characteristics or qualities of an item not covered in the other requirements and which are determined to be essential for identification.FEAT
Special Features:
Cable length: 119 inch; frequency range: 5000 - 5100 mhz, connector termination: 1st series a 600 sz 1 sock, ref des. 343tpp002a-4, mates w/ a-4 mmr2 / lpt4; 2nd series tnc pin, ref des. P1016mls, mates w/ j2 splitter 2 mmr 2
MRC:
The specification,standard,drawing,or similar instrument that specifies environmental and performance requirements or test conditions under which an item is tested and establishes acceptable limits within which the item must conform identified by an alphabetic and/or numeric reference number. includes the commercial and government entity (cage) code of the entity controlling the instrument.TEST
Test Data Document:
82918-30b9e2100 drawing (this is the basic governing drawing, such as a contractor drawing, original equipment manufacturer drawing, etc.; excludes any specification, standard or other document that may be referenced in a basic governing drawing)
