Part Number
DEMIL
Shelf Life
UOM
NIIN
Part Information
Inner ring and outer ring marked w/same serial no. Surface finish - inner and outer ring raceway surfaces 10 microinches aa, od surface of rollers 4 microinches aa, 0.1250 in. Diameter hole located on centerline of outer ring
NSN
National Stock Number:
TXT
Description:
Cylindrical Roller Bearing
MRC:
An overall measurement taken at right angles to the length of an item,in distinction from thickness.ABMK
Overall Width:
Between 1.1550 inches and 1.1600 inches
MRC:
The length of a straight line which passes through the center of a circular bore,and terminates at the circumference.ABXV
Bore Diameter:
Between 4.2990 inches and 4.3000 inches
MRC:
The overall length of a straight line which passes through the center of an item,and terminates at the outside circumference.ADGA
Overall Outside Diameter:
Between 5.2490 inches and 5.2500 inches
Outer Ring Width:
Between 1.1200 inches and 1.1250 inches
Inner Ring Width:
Between 1.1550 inches and 1.1600 inches
MRC:
An additional finishing process by which the surface of an item is altered in respect to polishing,grinding,and the like.AGYE
Surface Finish:
Ground
MRC:
The means used in manufacturing the retainer.AGYF
Retainer Fabrication Method:
Pressed
MRC:
The physical configuration of the bore.AGZD
Bore Shape:
Straight
MRC:
The ability of the bearing to provide freedom for axial movement of the shaft relative to the housing.AGZF
Locating Feature:
Nonlocating
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Steel
MRC:
The specification,standard,or manufacturers reference,and the classification designation,such as class,condition,temper,and the like,that identifies the material.MDCL
Material Specification:
114r2131, 77272 mfr ref single material response
MRC:
The specification,standard,drawing,or similar instrument that specifies environmental and performance requirements or test conditions under which an item is tested and establishes acceptable limits within which the item must conform identified by an alphabetic and/or numeric reference number. includes the commercial and government entity (cage) code of the entity controlling the instrument.TEST
Test Data Document:
51588-esj-74590 drawing (this is the basic governing drawing, such as a contractor drawing, original equipment manufacturer drawing, etc.; excludes any specification, standard or other document that may be referenced in a basic governing drawing)