Part Number
DEMIL
Shelf Life
UOM
NIIN
Part Information
Washer, countersunk and plain, for use with bolts and nuts up to and including 220 ksi ftu
NSN
National Stock Number:
TXT
Description:
Recessed Washer
MRC:
The length of a straight line which passes through the center of a hole,and terminates at the circumference.AAUB
Hole Diameter:
Between 0.789 inches and 0.793 inches
MRC:
The length of a straight line which passes through the center of a circular figure or body,and terminates at the outside circumference.ABKV
Outside Diameter:
Between 1.384 inches and 1.394 inches
MRC:
The length of a straight line which passes through the center of the recess,and terminates at the circumference.ABMD
Recess Diameter:
Between 0.981 inches and 0.991 inches
MRC:
A measurement of the smallest dimension of the material,in distinction from length or width.ABPX
Material Thickness:
Between 0.099 inches and 0.119 inches
MRC:
The national stock number or the identification information of the end equipment for which the item is a part.AGAV
End Application:
V-22 lrip e-nsn isil
Recess Angle:
45.0 degrees
MRC:
Those unusual or unique characteristics or qualities of an item not covered in the other requirements and which are determined to be essential for identification.FEAT
Special Features:
These washers are primarily for use with ms14181 bolts and ms14182 nuts. Ms14183-3 has been replaced by nasm14183 dated december 14, 1999
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Nickel alloy
MRC:
The specification,standard,or manufacturers reference,and the classification designation,such as class,condition,temper,and the like,that identifies the material.MDCL
Material Specification:
Ams 5596, ams 5597, ams 5662 assn standard single material response
MRC:
The metallic,nonmetallic,and/or chemical properties with which the item is plated,dipped,and/or coated.the treatment is designed to protect the surface(s) and cannot be wiped off.SFTT
Surface Treatment:
Passivate or cadmium
MRC:
The specification,standard,or manufacturers reference,and the classification designation,such as type,class,grade,and the like,that identifies the surface treatment material.STDC
Surface Treatment Specification:
Qq-p-p-35 federal specification 1st treatment response or qq-p-416 type ii, class 2 (passivation not required) federal specification 2nd treatment response
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the item.STYL
Style Designator:
15 recessed
