change location
321-802-5889
321-733-7477
2nd leg has 2 more holes, 0.139-0.144 in dia, centered 0.976 from open end and 6.356 & 7.262 from left edge; 1st leg has 7 semicircular cutouts on bottom edge with radii of 0.500 - see drawing for location and for placement of markings "a1, a2, ..., a8" and "f1, f2, ..., f8" across first leg and "a1, a2, ..., a8" across second leg; marking to be done in .12 high characters using find no. 1 mil-std-130
Identify with part number per mil-std-130, marking process per mil-m-13231, group iii; locate marking externally on one side approximately 0.500 inch from bottom/open end and 1.000 inch from right edge
Finish iaw mis-20007 ty i cnd b gr 2a (see dwg) mark iaw mil-std-130 weld iaw mis-19874 heat treat iaw mil-s-6090 dry film lube iaw mil-l-46010
Irregularly shaped - see drawing for details; includes bracket (-011) and cover, rear (-010); rubber stamp or stencil cage and part number (with revision) in black epoxy ink iaw a-a-56032 in 0.80-0.160 inch high characters per mil-std-130
Lirregularly shaped on top and left side - see drawing for details; rubber stamp or stencil cage and part number on underside with black epoxy ink iaw-a-a-56032 in 0.080-0.160 inch high characters per mil-std-130
Material 12 thk 302 stainless steel; p/n 9454407 in accordance with mil-std-130; contains a 2nd mounting hole diameter of min. 0.125, max0.130
Plate has an additional 4 apertures with a diameter of .290 - .320 inches thru, metal stamp. Engrave. Or electric are pencil on this surface in .09 - .50 high characters per mil-std-130
Wprotective finish per paragraph 24, exterior paint system, drawing 12350824, metal stamp, or electric arc pencil on this surface in .09-.50 high characters per mil-std-130; the diameter of the second aperture is .220 - .280 inches
2 odd shaped holes located on each side of item - identify in accordance with mil-std-130
Using black ink,apply per mil-std-130. Characters should be no more than .19 inches high; bond fn 5(cover) using sufficient quantities of fn 6 (adhesive-sealant) to insure a positive bond. A continuous emi/rfi seal must exist between panel and gasket bead
Consisting of the following parts and spec; 1:12323586 bracket; 2:ms20427-406; 1:nas1464-065-08c clip; bag and tag identification marking in accordance with requirementprescribed by mil-std-130; final protective finish spectt-c-490; treat per type 1 or 2; top coat: tt-p-636,tt-p-664 or spec tt-p-1757. Top coat enamel forest green per: spec mil-e-52798
Affix item 2 to item 1 in location shown,bag or tag with p/n 19200assy 9363076 per mil-std-130,qap 9363076 applies to this drw;consists of clamp holding 9363075,pad compression 9363080